Programmer 31
Chapter 2 Programming with Help Function
Curve
The pattern with curves is programmed.
The example in the left is used for explanation of
programming at the curve and the corner.
Be sure to press
twice for a split at corner points C or E. If a split is not made, the corner will
be round.
When a split is made When a split is not made
More intermediate points such as points B, D, F or G will create smooth curves.
Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Select with and press .
3. Move the work clamp with
. Press
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
4. Select with and press .
To Next Page
Loading...
