10 Programmer
Chapter 1 Preparations of operation
Turning power ON/OFF
Turning power ON
1. Switch ON the machine.
2. Press the foot switch pedal to lift the work clamp.
3. Set the pattern sheet.
Fix the pattern sheet with adhesive tape on the feed plate to prevent displacement.
4. Press the foot switch pedal to lower the work clamp.
5. Moving the needle closer to the pattern sheet by turning the pulley allows easier programming.
6. Press on the programmer.
The needle moves to the home position.
Foot switch pedal
Pattern sheet
2-3 mm
To Next Page
Loading...
