182 Programmer
Chapter 3 Programming with Command Function
Editing data
Moving symmetrically to the Y axis
Command to be used
Moving symmetrically to the Y axis passing the start point of sewing
This function is available only when the needle is at the home position.
1. Make sure that the needle is at the home position.
Press if the needle is not at the home position.
2. Input .
3. Press .
Moving symmetrically to the X axis
Command to be used
Moving symmetrically to the X axis passing the start point of sewing
This function is available only when the needle is at the home position.
1. Make sure that the needle is at the home position.
Press if the needle is not at the home position.
2. Input .
To Next Page
Loading...
