Programmer 135
Chapter 3 Programming with Command Function
Basting
Basting is programmed. The example in the le in the left is
used for explanation of basting programming from point C to
point F.
Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Move the work clamp with . Press
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Repeat step 2 and create the program to point
C.
4. Input point C and press
.
Input the basting command.
5. Move the work clamp with . Press
when the needle point is at point D of the
pattern.
6. Repeat steps 4 and 5 and create the program to
point F.
7. Create the program to points G and H as in step
2.
To Next Page
Loading...
