130 Programmer
Chapter 3 Programming with Command Function
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
Curve
A pattern with curves is programmed.
Be sure to press
for a split at corner points C or E. If a split is not made, the corner
will be round.
When a split is made When a split is not made
More intermediate points such as points B, D, F or G will create smooth curves.
Programming
1. Press .
The work clamp moves to the home position and
the programmer screen is displayed.
2. Move the work clamp with . Press
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
To Next Page
Loading...
