Brother BAS-311F-0 - Table of Extended Option Output

Programmer 207
Chapter 4 Extended Option Output
Table of extended option output
Common output (condition) *1 Connector *2
Extended option
output No.
Part name Condition Connector No. Pin No.
1 2 stage tension Memory SW-0b ON 5
Air wiper Memory SW-09 ON 62
Pattern engraving drill Memory SW-10 ON 6
Auto eject Memory SW-03 ON 73
Upper/lower engraving Memory SW-10 ON
P4(AIR)
7
4 Right work clamp turnover Memory SW-19 ON 1
5 Left work clamp turnover Memory SW-19 ON 2
6 3
7 4
8 5
9 Signal tower green Memory SW-15 ON 6
10 Signal tower yellow Memory SW-15 ON 7
11 Signal tower red Memory SW-15 ON
P21(EXOUT)
8
12 NEEDLE DIPSWB-4 ON 8
13 FLIP DIPSWA-6 ON 4
14 FOOT DIPSWC-6 ON 3
15 LCLAMP When 2 stage pressure
bar is used
2
16 RCLAMP For the air type
P4(AIR)
1
*1 Input available for optional parts. It is not used as extended option input if conditions are met.
*2 Connector number and pin number on the main circuit board in the control box
• The common terminal of connector P4 (AIR) is pin No. 11 at +24V.
• The common terminal of connector P21 (EXOUT) is pin No. 9 or 10 at +24V.