Brother BAS-311F-0 - Adding Sewing Point before the First Stitch

150 Programmer
Chapter 3 Programming with Command Function
4. The needle point moves to 1'.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
Adding sewing point before the first stitch
A point is added before the current sewing point to change
the sewing start position.
The example in the left is used for explanation of changing
the sewing start position from 1 to 1'.
Calling data
1. Specify the program number on the operation
panel and press the read/write switch to read
the data.
Moving to position 1.
1. Press and press .
The work clamp moves to the start position.