Programmer 151
Chapter 3 Programming with Command Function
Programming a new point.
1. Press
.
2. Move the work clamp with
so that the
needle point is at 1' of the pattern.
Record the coordinates (values of and ).
3. Press .
1' is programmed.
4. Move the work clamp with to the
opposite position of coordinates recorded in
step 2 and press
.
If the moving distance is long, press .
5. Press .
The work clamp returns to the home position.
Deleting 1
1. Press and press .
The needle point returns to the first stitch.
2. Press .
3. Input the number of stitches to be deleted and
press
.
The example is deleting 1 stitch. Press .
4. The needle point moves to 1'.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
To Next Page
Loading...
Need help?
General
