158 Programmer
Chapter 3 Programming with Command Function
2. Move the work clamp with so that the
needle point is at B of the pattern.
Record the coordinates (values of and ).
If the moving distance is long, press
before
movement.
3. Press .
The work clamp moves to the home position.
4. Press and press .
The needle point moves to point C.
5. Move the work clamp with for the
coordinates recorded in step 2.
The moved point is now D.
If the moving distance is long, press
before movement.
6. Turn the pulley with a hand and put a marking
with the needle to indicate the position of point
D.
7. Turn the pulley with a hand and move the
needle to the top point.
8. Press
.
The work clamp returns to the home position.
9. Move the work clamp with . Press
when the needle point is at D of the pattern.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
To Next Page
Loading...
