Programmer 145
Chapter 3 Programming with Command Function
Resizing
1. Move the needle to the reference point of
resizing with
.
The pattern is resized to the home position if the
needle is not moved.
2. Press and press .
Input the resizing command.
3. Press and press .
Input the resizing percentage for the X axis.
Specify the magnification percentage by 3 digits in
. 150% is specified in the example.
4. Press and press .
Input the resizing percentage for the Y axis.
Specify the magnification percentage by 3 digits
in
. 150% is specified in the example.
5. Input the stitch length. Press .
If the stitch length is 0.0, the pattern is resized
with the same number of stitches as the original
data.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1. Press .
To Next Page
Loading...
Need help?
General
