Programmer 37
Chapter 2 Programming with Help Function
3. Move the work clamp with . Press
when the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
4. Program pattern 1.
5. Press
after input of point B.
The number of pressing depends on the
programming method for pattern 1.
When
is used for programming, press twice.
When each stitch is programmed, press once.
6. Select with and press .
7. Move the work clamp with
. Press
when the needle point is at point C of the
pattern.
8. Press
.
9. Program pattern 2.
10. When point D is programmed, press
.
The number of pressing depends on the
programming method for pattern 2.
When
is used for programming, press twice.
When each stitch is programmed, press once.
Inputting the end code
1. Select with and press .
2. Select the end code type with
and press
.
"111" is selected in the example. Press and the
work clamp returns to the first stitch (point A).
3. Press .
The work clamp returns to the home position.
To Next Page
Loading...
Need help?
General
