Programmer 39
Chapter 2 Programming with Help Function
3. Move the work clamp with . Press
when the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
4. Select with and press .
5. Move the work clamp with
. Press
when the needle point is at point B of the
pattern.
6. Repeat step 5 and create the program to point
C.
7. When point C is programmed, press
.
8. Select
with and press .
9. Move the work clamp with
. Press
when the needle point is at point D of the pattern.
10. Repeat step 9 and create the program to point F.
11. Press
.
12. Select
with and press .
13. Create the program to point H.
14. When point H is programmed, press
.
To Next Page
Loading...
Need help?
General
