Brother BAS-311F-0 - Page 46

Programmer 45
Chapter 2 Programming with Help Function
8. Press .
9. Select
with and press .
10. Select ON/OFF of needle stopping at the bottom
with
and press
.
11. Program pattern 2.
12. Program pattern 3 in the similar manner.
13. When pattern 3 is programmed, press
.
Inputting the end code
1. Select with and press .
2. Select the end code type with
and press
.
"111" is selected in the example. Press and the
work clamp returns to the first stitch (point A).
3. Press .
The work clamp returns to the home position.
Saving
1. Select with and press .