Brother PE-Design Next - Page 170

168
Tutorial 10-3: Embroidering With the Jumbo Frame
Click 1 to view the next side of the embroidery
design.
■ Saving the design
The entire design is saved as a single file (.pes).
c
“Transferring to a machine by using USB
media” on page 175, and “Transferring
directly to a machine’s memory” on
page 176
Step 4 Attaching stabilizer to the
fabric
Always use stabilizer when embroidering.
For large designs split into sections, the stabilizer
must be attached to the fabric, for example, by using
iron-on stabilizer, self-adhesive stabilizer or spray
adhesive. Use stabilizer appropriate for the fabric.
In addition, be sure to use stabilizer that is strong
enough and large enough for the entire
embroidering area. You may need to attach two
layers if thin stabilizer is used.
c
See more information about stabilizer,
“Step 4 Attaching stabilizer to the fabric”
on page 156.
Step 5 Embroidering
Embroider using the embroidery positioning stickers
included with the embroidery machine. These
stickers are detected by the embroidery machine’s
built-in camera to automatically position the fabric.
Hoop the fabric in the embroidery frame.
Attach the embroidery frame to the
embroidery machine.
Select the pattern for side 1, and then start the
embroidery machine to embroider the side 1
embroidering area.
b Memo:
To view the embroidery pattern click on
Design Property to open the Design
Property
dialog box. Uncheck the Show
about selected Object(s)
to view the
separate sides.
a Note:
An embroidery design for the jumbo frame
cannot be transferred to the machine by
using an original card. Transfer these
designs directly to the machine's memory or
to the machine by using USB media.
2
1
1
2
3
XE8656-001.book Page 168 Monday, May 24, 2010 5:44 PM