Burford 2000 - Seven Segment LED, Error Codes, ContD

Troubleshooting 113
 Seven Segment LED, Error Codes, cont’d
CODE DESCRIPTION CODE DESCRIPTION
H001 Main Enclosure power switched on. E123
Leading edge of hook prox
not found.
H002 External reset detected. E124
Can't move hook to home
position.
H003
Servo Tyer homing sequence aborted
by operator.
E125
Twister hook motor not
moving.
H004
Servo Tyer not ready, close door and
push “START”.
E126
Twister hook jammed or
encoder fault.
H005
Ribbon drop detected. Thread Servo
Tyer.
E127
Twister hook home prox not
detected.
H006 Two bags were too close together. E131
Unable to control shear
while homing.
H007
Tie cycle aborted, not enough ribbon
used.
E132
Trailing edge of shear prox
not found.
H008 Heel detected, too much ribbon used. E133
Leading edge of shear prox
not found.
H011 Needle at end of forward travel. E134
Can't move holder shear to
home
position.
H012 Needle at end of backward travel. E135
Holder shear motor not
moving.
H021 Twister hook at end of forward travel. E136
Holder shear jammed or
encoder fault.
H022
Twister hook at end of backward
travel.
E137
Holder shear home prox not
detected.
H031 Holder shear at end of forward travel. E146
Gathering belts jammed or
encoder fault.
H032
Holder shear at end of backward
travel.
E151
Spurious interrupt detected
by CPU.
H051 Motor control loop ran out of time. E152
General interrupt detected
by CPU.
H052 Command table out of order. E153
Bus error at 0x______from
0x______.
H159 Loss of clock: push “RUN”. E154
Address error at
0x_____from 0x______.