16
Chapter 1
Conveyor Requirements
Depending on conveyor speed and flight spacing, the Servo Tyer is capable of operating
speeds of up to 100 packages per minute. The Servo Tyer operates on a nominal 110
Volts, 60 Hz, single-phase alternating current. 15-amp service is recommended. Servo
Tyer connections for bagger interlock and safety circuits are provided standard. A counter
signal is provided which can be used in conjunction with an external counter (not
provided).
On flighted conveyors, flight spacing up to 18” may be used, but the tyer can have a
higher production rate (packages per minute) with a small flight spacing, such as nine
inches. This tyer can also be used on belted conveyors that provide consistent spacing.
All referenced measurements are in inches except as noted.
Minimum size for a service transformer must be rated at least 1.8KVA
To Next Page
Loading...
