150
Chapter 7
Flow Chart 0-35 Twist Tie Breaks During Tying
Twist tie ribbon breaks during tying operation
SAFETY WARNING:
The following troubleshooting procedure may require that tests be made with the electrical enclosures
open and power turned “ON”. These tests should only be conducted by authorized personnel who are
aware of the electrical and mechanical hazards present.
Excessive ribbon
tension.
Poor quality
ribbon.
See Section 5.13
for proper tension
adjustment.
Replace ribbon.
Worn or
damaged parts.
Check for wear and
damage on the break arm,
needle rollers, dancer arm
and ½” cam follower.
To Next Page
Loading...
