Operation 65
Changing And Threading The Ribbon,cont’d
9. Close the discharge cover and press the “RUN”
button to home the unit.
10. While letting the dancer arm relax to its extended
position, hold the ribbon firmly and press the
“THREAD” button on the front of the control panel.
The needle will activate and push the ribbon into the
open jaw of the holder/shear. The holder/shear will
rotate and catch the ribbon and the needle will move
back to home position. The ribbon will automatically
be adjusted to the proper tension.
Fig. 0-1 LH Ribbon Routing
To Next Page
Loading...
