Operation 67
Daily Startup
This is an example of a normal operator start up procedure.
1. Check that the Servo Tyer main disconnect on the main
enclosure is turned on.
11. Push the master “ON” button on the front of the Main
Enclosure. This will supply power to the Servo Tyer
electronics, but does not supply power to the servo
motors.
12. Push the “RUN” button on the control panel.
This will supply power to the servo motors
and start the homing sequence. When the
homing sequence is successfully completed,
the Servo Tyer is in the run mode.
To Next Page
Loading...
