Burford 2000 - Flow Chart 0-39 Holes Being Formed in Bag

154 Chapter 7
Flow Chart 0-39 Holes Being formed In Bag
Holes being formed in the bag
SAFETY WARNING:
The following troubleshooting procedure may require that tests be made with the electrical enclosures
open and power turned “ON”. These tests should only be conducted by authorized personnel who are
aware of the electrical and mechanical hazards present.
Too much ribbon
tension.
Too many twists.
Tie tightness
creating holes.
Belts tearing
holes in bags
See Section
5.13.
See Section
5.19.
See Section
5.15.
Smooth sharp
edges on belts.
Wear on front
covers (shiny or
slick surfaces).
Replace covers.