Burford 2000 - Flow Chart 0-36 Ties Not Centered on Product

Troubleshooting 151
Flow Chart 0-36 Ties Not Centered On Product
Ties are not centered on product
SAFETY WARNING:
The following troubleshooting procedure may require that tests be made with the electrical enclosures
open and power turned “ON”. These tests should only be conducted by authorized personnel who are
aware of the electrical and mechanical hazards present.
Bag tucked into itself
caused by excessive
air jet blowing bag
away from scoops on
Mark 50 type bagger.
Tyer is too high or too
low from product.
Reduce strength of air
jet.
Raise or lower tyer as
necessary.
Belt speed traveling
too fast or too slow.
Increase or decrease
belt speed as
necessary.