Burford 2000 - Flow Chart 0-38 Ribbon Wraps Around Hook Shaft

Troubleshooting 153
Flow Chart 0-38 Ribbon Wraps Around Hook Shaft
Ribbon wraps around twister hook shaft
SAFETY WARNING:
The following troubleshooting procedure may require that tests be made with the electrical enclosures
open and power turned “ON”. These tests should only be conducted by authorized personnel who are
aware of the electrical and mechanical hazards present.
Twister hook
shaft is too close
to holder shear.
Move hook shaft
to proper
spacing. See
Section 5.14.
Holder shear
motor encoder
bad.
Replace holder
shear encoder.