Burford 2000 - Flow Chart 0-40 Excessive Wear on Gathering Belts

Troubleshooting 155
Flow Chart 0-40 Excessive Wear On Gathering Belts
Excessive wear on gathering belts
SAFETY WARNING:
The following troubleshooting procedure may require that tests be made with the electrical enclosures
open and power turned “ON”. These tests should only be conducted by authorized personnel who are
aware of the electrical and mechanical hazards present.
Belts running at
excessive
speed.
Belts running for
long periods with
no bags going
through tyer.
Belts teeth not
aligned above
each other.
Set belt speed to
minimum
required speed.
Turn “OFF” tyer
when it is not in
use.
Align teeth. See
Section 5.12.