Burkert 8792 - Maintenance; Error Messages and Malfunctions

224
Maintenance and Troubleshooting
34. MAINTENANCE
The Type 8792/8793 is maintenance-free when operated according to the instructions in this manual.
35. ERROR MESSAGES AND MALFUNCTIONS
35.1. Error messages on the display
35.1.1. General error messages
Display Causes of error Remedial action
min
Minimum input value has been reached Do not reduce value further
max
Maximum input value has been reached Do not increase value further
CMD error
Signal error
Set-point value positioner (positioner)
Check signal
SP error
Signal error
Set-point value process controller
Check signal
PV error
Signal error
Actual value process controller
Check signal
PT100 error
Signal error
Actual value Pt-100
Check signal
invalid Code
Incorrect access code Input correct access code
EEPROM fault
EEPROM defective Not possible, device defective
Table 125: General error message
english
Type 8792, 8793