7
General Information
Safety Instructions
2. AUTHORIZED USE
Incorrect use of the Type 8792 and 8793 can be dangerous to people, nearby equipment and the
environment.
The device is designed for the open-loop control and closed-loop control of media.
▶ In the potentially explosive area use only devices with the Ex additional plate.
▶ For use in the potentially explosive area follow the Ex additional instructions and the instructions on the Ex
additional plate.
▶ The device must not be exposed to direct sunlight.
▶ Pulsating direct voltage (rectified alternating voltage without smoothing) must not be used as operating
voltage.
▶ During use observe the permitted data, the operating conditions and conditions of use specified in the con-
tract documents and operating instructions, as described in chapter “Description of System” - “10. Technical
data” in this manual and in the valve manual for the respective pneumatically actuated valve.
▶ The device may be used only in conjunction with third-party devices and components recommended and
authorised by Bürkert.
▶ In view of the wide range of possible application cases, check whether the device is suitable for the specific
application case and check this out if required.
▶ Correct transportation, correct storage and installation and careful use and maintenance are essential for reli-
able and faultless operation.
▶ Use the Type 8792 and 8793 only as intended.
2.1. Restrictions
If exporting the system/device, observe any existing restrictions.
english
Type 8792, 8793
Type 8792, 8793
To Next Page
Loading...
