7
Tap the WEP key you have edited.
Using WPA-PSK or WPA2-PSK
1
Tap <WPA/WPA2-PSK>.
2
Select an encryption method.
<Auto>
Sets the machine to automatically select AES-CCMP or TKIP to match the setting of the wireless router.
<AES-CCMP>
Sets AES-CCMP as the encryption method.
3
Enter the network key that you have written down.
● Enter the network key using the numeric keys, and tap <Apply>.
8
Tap <Yes>.
If an error message is displayed during setup
● Tap <Close>, check whether the specied settings are correct, and return to step 5.
9
Check that the Wi-Fi indicator is blinking on the operation panel.
● The Wi-Fi indicator blinks when a wireless router is detected.
➠ When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi
indicator lights up. Wait approximately 2 minutes (until the automatic settings of IP address and other
items are complete).
Network
431
To Next Page
Loading...
