Canon MF418x - Receiving I-Faxes

Receiving I-Faxes
0UWX-041
◼ When an I-Fax Arrives
When an I-Fax arrives, the Processing/Data indicator on the operation panel blinks. After the I-Fax is completely
received, the document is printed out automatically and the indicator goes out.
● To cancel reception, press <RX Job> <Job Status> Select the document on the <RX Job Status>
screen <Delete> <Yes>
◼
Receiving I-Faxes Manually
If you want to connect to the server before receiving I-Faxes automatically, or if you want to congure the machine so
that it does not receive I-Faxes automatically, use the method below to receive I-Faxes manually.
<RX Job> <Check I-Fax RX>
➠
Connect to the server. If there is a document on the server, printing begins.
◼
Printout Paper
Regardless of the received document size, incoming I-Faxes are printed at the size specied in <RX Print Size>.
RX
Print Size(P. 670)
● If paper of the size specied in <RX Print Size> is not loaded in the paper drawer, the <No Paper> error
message is displayed. When an Error Message Appears(P. 734)
● If you want to print received documents on both sides of paper: Print on Both Sides(P. 670)
● If you want to continue printing even when toner is running low: Continue Printing When Amount in
Cartridge Is Low(P. 664)
Faxing
231