Alternately sends and receives communication data. Select when the machine is connected to a
networking device using half duplex.
<Full Duplex>
Simultaneously sends and receives communication data. Use this setting for most environments.
3
Select the Ethernet type.
● Tap <Ethernet Type> select the Ethernet type.
● When <Communication Mode> is set to <Half Duplex>, you cannot select <1000BASE-T>.
4
5
Restart the machine.
● Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
LINKS
Changing the Maximum Transmission Unit(P. 486)
Setting a Wait Time for Connecting to a Network(P. 487)
Network
485
To Next Page
Loading...
