Canon TX-4100 - Page 244

Communication mode Wireless Direct
Channel 3
Wi-Fi security WPA2-PSK (AES)
IPv4 address XXX. XXX. XXX. XXX (12 characters)
IPv4 subnet mask XXX. XXX. XXX. XXX (12 characters)
IPv4 default gateway XXX. XXX. XXX. XXX (12 characters)
IPv4 DNS dynamic settings Enable / Disable
IPv4 DNS host name XXXXXXXXXXXX
IPv4 DNS domain name XXXXXXXXXXXXX
XXXXXXXXXXXXX
XXXXXXXXXXXXX
XXXXXXXXXXXXX
XXXXXXXXXXXX (up to 64 characters)
IPv6 link-local address XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX (32 characters)
IPv6 link-local prefix length XXX (up to 3 digits)
MAC address XX:XX:XX:XX:XX:XX (12 characters)
IPsec settings Disable
Printer name XXXXXXXXXXXXXXX (up to 15 characters)
Bonjour service name XXXXXXXXXXXXX
XXXXXXXXXXXXX
XXXXXXXXXXXXX
XXXXXXXXXXXXX (up to 52 characters)
※1 means printer's model name
("XX" represents alphanumeric characters.)
To change the setting, tap Settings.
◦ Enable/disable Wireless Direct◦
Select Yes to wirelessly connect without wireless router.
◦ Update SSID/password◦
Updates the identifier (SSID) and password.
◦ Wireless Direct network (SSID)◦
Changes the name (device name) of the printer displayed on Wi-Fi Direct compatible device.
◦ Connection request confirmation◦
Changes the display / non-display of the confirmation screen when Wi-Fi Direct compatible devices
are connected to the printer.
Note
• By tapping Advanced, you can set LAN in detail.•
For the items that can be set, see the following.
244