Cisco 7925G Administration Guide

For more information, see..DescriptionNetwork setting
DHCP Settings, on page 121Internet Protocol (IP) address of the phone.IP Address
Subnet mask used by the phone.Subnet Mask
Primary gateway used by the phone.Default Router 1
Name of the Domain Name System (DNS)
domain in which the phone resides.
Domain Name
Primary DNS server used by the phone.DNS Server 1
Optional backup DNS server used by the
phone.
DNS Server 2
Set Alternate TFTP Server, on page 122Yes: This option assigns an alternative
Trivial File Transfer Protocol (TFTP) server.
No: This option uses the TFTP server
assigned by DHCP.
Alternate TFTP
IP address for the primary TFTP server used
by the phone. If you set Alternate TFTP
option to Yes, you must enter a nonzero
value for this option.
TFTP Server 1
Optional backup TFTP server that the phone
uses if the primary TFTP server is not
available.
TFTP Server 2
Cisco Unified Communications Manager
Administration Guide
IP address for the server where the phone
receives firmware updates.
Load Server
Change Cisco Discovery Protocol
Settings, on page 123
Cisco Unified Communications Manager
Administration Guide
Enables or disables Cisco Discovery Protocol
(CDP) for the phone in Cisco Unified
Communications Manager Administration.
CDP Enabled
Deletes the phone configuration and sets to
factory defaults.
Erase
Configuration
Product-Specific Fields for Cisco Unified
Wireless IP Phone 7925G, 7925G-EX,
and 7926G, on page 162
Yes: Indicates that the speakerphone is
disabled on the phone.
No: Indicates that the speakerphone is
enabled on the phone.
Handset Only
Mode
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
120
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Settings
Network Settings

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g