Cisco 7925G Administration Guide

DescriptionItem
Name of the DNS in which the phone resides.Domain Name
IP address of the phone.IP Address
Subnet mask used by the phone.Subnet Mask
Primary TFTP server used by the phone.TFTP Server 1
Secondary TFTP server used by the phone.TFTP Server 2
IP address for the default gateway used by the phone.Default Router 1
Primary DNS server used by the phone.DNS Server 1
Backup DNS server used by the phone.DNS Server 2
Host name or IP address for the alternate server that the phone uses for
firmware upgrades.
Load Server
Indicates whether the network is using Cisco Discovery Protocol (CDP).CDP Enabled
Indicates whether this phone is using DHCP for its IP address assignment
or not.
DHCP Enabled
Indicates whether this phone uses a TFTP server other than the one assigned
by DHCP.
Alternate TFTP
WLAN
Name of the network profile that the phone is currently using.Profile Name
Service Set ID that the phone is currently using.SSID
Wireless signal mode that the phone is currently using.802.11 Mode
Indicates when the phone scans. Configured in the Cisco Unified
Communications Manager Administration.
Scan Mode
Indicates the Traffic Stream Rate Set (TSRS) information element from
CCX 1, which can define a data range for the client to use.
Restricted Data Rates
Type of power save mode that the phone uses to save battery power: PS-Poll
or U-APSD.
Call Power Save Mode
Authentication method that the phone is currently using in the wireless
network.
Security Mode
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
181
Security, Device, Model, Status, and Call Statistics Information
Device Information Fields

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g