Claas ROLLANT 240 User Manual

8.1.6 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Setting up the baler
Blockage in the roller crop guard
To clear a blockage in the roller crop guard, note the
following.
– Set the pick-up to the lower position.
– Take off the crop guard (H).
– Lift up the roller crop guard (A) in order to tighten
up the chain (D) on both sides in the hook (E).
– Clear the blockage in the baler.
Attention!
Damage to the roller crop press.
☞ Never lift the pickup hydraulically for
cleaning: Danger of collision between the
roller crop presses and the front part of the
machine.
Danger!
There is a risk of injury when clearing the
blockage by hand!
☞ Switch off the PTO-shaft, shut down the
tractor engine and take out the ignition
key.
☞ Wear gloves!
!
Attention!
Damage to side flaps
☞ Never open or close the side flap where
the roller crop guard and the pick-up are
set to a higher level.
– Set the roller crop guard (A) back to its working
position.
– Fit on the crop guard (H).
(Fig. 8, 13)
E
D
C
H
13

Claas ROLLANT 240 Specifications

General

Brand	Claas
Model	ROLLANT 240
Category	Lawn and Garden Equipment
Language	English