Claas ROLLANT 240 User Manual

000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 8.2.9
Setting up the baler
Setting the number of net wraps
ROLLANT 240/250/254/255 with standard controls:
The number of net wraps can be selected by adjusting
the eccentric end stop (L). The actual setting of the
end stop (L) depends on the condition of the crop.
Under normal harvesting conditions, 2.2 wraps will be
sufficient. For exceptionally dry or brittle crops or if the
bales are to be exposed to extra strain due to outdoor
storage or transport, set the limit stop (L) further down.
(Fig. 16, 17)
ROLLANT 254/255 with CCT:
All adjustments are made with the Control Terminal/
Claas Communicator. The end stop (L) is always in
hole (5) and in position (B).
Note!
If the adjustment and position of (L) are
changed, the number of net wraps (Control
Terminal/Claas Communicator) does not
correspond to the actual number of wraps.
(Fig. 16, 17)
16
17
Hole Stop
position
Number of
wraps
1A
B
4,1
3,8
2A
B
3,5
3,2
3A
B
2,9
2,5
4A
B
2,2
1,9
5A
B
1,6
1,3

Claas ROLLANT 240 Specifications

General

Brand	Claas
Model	ROLLANT 240
Category	Lawn and Garden Equipment
Language	English