Claas ROLLANT 240 User Manual

000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 9.2.9
Operation
Round baler with net wrapping
Press push button (2) on the control box to activate the
net wrapping system. The status display (light) (7)
confirms the selection “net wrapping”.
Round baler with twine and net wrapping
Balers with twine and net wrapping are factory-set to
twine wrapping by default.
To change from twine to net wrapping and vice-versa:
– Adjust drive
(see chapter "Adjusting the baler") and
– press pushbutton (1 or 2) on the control box to
activate the net or twine wrapping.
The status display (light) (7 or 8) shows the active
wrapping mode.
During the compression process, the ROLLANT 254/
255 with High Convenience Operation handles these
settings from the control panel or Claas
Communicator.
Round baler with twine wrapping
Press pushbutton (1) on the control box to activate the
twine wrapping system. The status display (light) (8)
confirms the selection “twine wrapping”.
Note!
When initiating the wrapping process make sure
that both twine ends are drawn in. If only one
twine end is drawn in run the wrapping process
to the end and restart it by pressing push button
(5).
(Fig. 12)
8
1
5
7
2
12

Claas ROLLANT 240 Specifications

General

Brand	Claas
Model	ROLLANT 240
Category	Lawn and Garden Equipment
Language	English