EasyManuals Logo

Claas ROLLANT 240 User Manual

Claas ROLLANT 240
284 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #251 background imageLoading...
Page #251 background image
000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 14.4.3
Maintenance
Lubricant
Environment!
Only use biodegradable chain lubricating oil, such as
the synthetic "CLAAS roller chain oil Bio HEES 46",
hydraulic oil or engine oil.
CLAAS spare part-no. for 5L/1.32 US gal-drum:
147 457.0
CLAAS spare part-no. for 20L/5.28 US gal-drum:
147 456.0
Attention!
Do not mix in any diesel fuel or other easily
inflammable substances.
Use only clean oil.
The rubber rollers must never come in
contact with oil or grease.
(Fig.1,2,3,8)
Bearings to be greased and main lubrication
installation (for ROLLANT 254/255 - optional)
After every week of work, remove cap (K) of grease
fitting (S) and cap (R) of pin (P) from the three modules
of the central lubrication system. Insert grease
(multipurpose grease) through the respective
lubrication nozzle (S) until the pin (P) has moved in
and out six times.
Note!
If grease comes out of the cap (O), there is too
much pressure in the lubrication system.
Possible causes: Excessive pressure from the grease
gun (if using air pressure lubrication pump, set
pressure (L) to 180 bar/2610 psi) or a blocked
lubrication hose.
After greasing, operate the baler for about three
minutes.
For balers without a main lubrication installation that
have bearings needing to be greased, every bearing
has to be greased by hand.
(Fig. 9)
8
R
O
S
K
P
9

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Claas ROLLANT 240 and is the answer not in the manual?

Claas ROLLANT 240 Specifications

General IconGeneral
BrandClaas
ModelROLLANT 240
CategoryLawn and Garden Equipment
LanguageEnglish

Related product manuals