9.1.6 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Operation
Manual override of automatic wrapping operation
Premature triggering of the wrapping operation:
This is used in cases where there is not enough
windrow left in the field for a full bale.
At any time during the baling operation, and until just
before the automatic wrapping operation would
normally begin (twine or netting), the wrapping
operation can be triggered prematurely by pressing the
pushbutton switch (4).
Delaying the wrapping operation:
This is used when a delay in the wrapping operation is
required in order to reach the end of a windrow.
At any time during the baling operation and until
just before the automatic wrapping operation
(twine or net) would normally begin, the wrapping
operation can be delayed by pressing the pushbutton
switch (3).
The wrapping operation will not begin until the
pushbutton (3) has been released.
Note!
The tailgate is pushed open about 5 cm (1.97 in)
by the baling chamber when it is completely
filled. This pushes a switch which starts the
automatic wrapping operation.
When the wrapping operation is delayed and not
automatically started, then the baling chamber is not
filled completely.
Then the baling chamber must be filled further or the
wrapping operation must be started prematurely.
(Fig. 7)
G
N
1
2
3
4
A
E
28268
7
To Next Page
Loading...
Need help?
General
