9.1.8 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Operation
When the tailgate is closed, press the tailgate switch
until the illuminated pushbutton switch (3) is lit up and
the warning tone sounds.
Now measure the time until the illuminated pushbutton
switch (3) goes out. Once the delay sequence is
complete, the solenoid clutch for the wrapping
sequence will be engaged (audible).
The delay time can be reset, if this is required.
(Fig. 9, 10)
Setting the delay time
The delay time can be set from a minimum of 1 second
to a maximum of 10 seconds.
Note!
A watch with a second hand is needed to set the
delay time. If more than 10 seconds are set, the
baler changes to the “manual net wrapping”
operating mode.
Read the following steps carefully. After you have read
them, follow the steps one by one:
1. Switch off the control box.
2. Press and hold pushbutton switches (3) and (4) at
the same time.
3. Switch on the control box.
4. The pushbutton switch (3) lights up. Now set the
delay time you require (learn mode).
5. As soon as the required delay time is set, let go of
both buttons (3) and (4).
6. Switch off the control box and then switch it back
on.
The baler will now operate on the new delay time.
Note!
The light in pushbutton switch (3) only goes on
during learn mode and goes out after 10
seconds.
(Fig. 10)
9
10
To Next Page
Loading...
Need help?
General
