10.1.4 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Control Terminal
Setting the type of wrapping
(Fig. 1, 4)
Start wrapping cycle manually
(Fig. 1)
Delay wrapping cycle
Note!
The "Delay wrapping process" function is only
active in the "Job data" 1/1 and 1/2 menu.
(Fig. 1)
Pick-up up / down (without floating position)
(Fig. 1)
200414
C
D
4
Press this key as many times as needed
until the desired status display appears:
C = Twine wrapping
D = Net wrapping
Press this key briefly to manually start the
wrapping cycle.
Use manual wrapping when, for example,
there is not enough crop at the end of a
windrow for the last bale.
Press this key before wrapping has been
triggered by the automatic unit. Hold down
the key for as long as you wish to delay the
process.
Delayed wrapping can be used, for
example, to delay the automatic wrapping
operation until the end of a windrow can be
reached.
Pick-up up: Hold key depressed, until the
desired position is reached.
Pick-up down: Hold key depressed, until
the desired position is reached.
To Next Page
Loading...
Need help?
General
