000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 4.1.3
Safety precautions
Attention!
Collision of high speed road traffic and
slow moving machines can cause
personal injury or death.
Stay off slopes too steep for safe
operation. Shift down before you start up
or down a hill with heavy load. Avoid ”free
wheeling”.
Danger!
Provide a first aid kit for use in case of
accident.
As a safety precaution, it is suggested one or
more fire extinguishers be carried on the Baler
at all times. Fire extinguishers must be
purchased from Fire & Safety equipment supply
store.
Attention!
Look for this symbol to point out important
safety precautions. It means BECOME
ALERT! YOUR SAFETY IS INVOLVED.
This machine is of metric design.
Measurements in this manual are metric
with the customary U.S. measurements
following. Use only metric hardware and
tools as specified.
Replacement Parts:
– When replacement parts are necessary for
periodic maintenance and servicing, genuine
CLAAS replacements must be used to restore
your equipment to original specifications.
– CLAAS will not claim responsibility for usage of
unapproved parts and/or accessories and
damages as a result of their usage.
Safety signs
Attention!
Install new safety signs if the old safety
signs are destroyed, lost, painted over or
can not be read. When parts are replaced
that have safety signs, make sure you
install a new safety sign with each new
part.
Note!
New safety signs are available from your
Dealer or write to:
CLAAS OF AMERICA Inc.
P.O.Box 3008
3030 Norcross Drive
Columbus Indiana 47201
USA.
Transporting baler on a public thoroughfare
Whenever a Baler is to be transported on a public
thoroughfare, the following preparation of the Baler
should be made:
• Position pickup in the transport position. Close
gate, raise pickup and converging wheels, if
equipped.
• Make sure warning devices, such as slow
moving vehicle emblem, reflectors, etc., are
installed, clean and are in good condition.
• Use flashinglights according to local laws. Keep
SMV emblem clean and visible. Replace SMV
emblem when damaged or sun faded.
• For reference purposes, measure the overall
width and height of the Baler. These
measurements are particularly important for
transporting along narrow roads and where
underpasses may be encountered.
• If the Baler hydraulic system is equipped with
an accumulator, make sure the accumulator
shutoff valve is closed.
To Next Page
Loading...
Need help?
General
