000 299 119 5 - BA ROLLANT 240 - 250 - 254 - 255 9.1.7
Operation
Delay time for automatic net wrapping
The delay time is the time between completing the
bale and the start of the automatic net wrapping
sequence. This time allows the operator to bring the
tractor and the baler to a complete stop.
Automatic net wrapping begins when:
– the light in the pushbutton switch (3) on the control
box goes on,
– there is an acoustic warning tone.
The delay time to stop the tractor is set from the
factory to a default time of 4 seconds. Once this time
has passed, the rotating bale will take up the net.
Checking the delay time
Switch on the control box; to do this, switch the rotary
switch (2) to position (A) or (E).
0 = Power supply switched off
E = Knives in cutting chamber
A = Knives out of cutting chamber
Note!
Only operate the rotary switch (2) when the
baler is stationary.
When the system is operational, then the control lamp
in rotary switch (1) is illuminated.
If the control lamp in the rotary switch (1) flashes
repeatedly, then the baler’s automatic net wrapping
system is not operational. If this is the case, possible
reasons are listed in the operator's book under section
9.1.1.
(Fig. 8)
G
N
1
2
3
4
A
E
28268
8
To Next Page
Loading...
Need help?
General
