14.1.4 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Maintenance
Eccentricity
Attention!
Unstable running of the round baler causes
material fatigue and fractures.
☞ Deposits of dirt in rotating parts of the
machine, particularly in the cutting and
conveyor rotor must be thoroughly
removed at regular intervals.
Welding work When performing electric welding work on the round
baler proceed as follows:
1. Disconnect cable connections to the tractor.
2. Disconnect the plug connection from the control
box or control terminal.
3. Pull all modules out.
4. Always fasten the ground clamp of the welding
unit in the immediate vicinity of the welding
location.
Bolts Check all bolts for tightness, retighten if necessary.
To Next Page
Loading...
