7.1.2 BA ROLLANT 240 - 250 - 254 - 255 - 000 299 119 5
Prior to operation
25. Check wheel nuts or wheel studs for tight fit
(tightening torques see »Technical Data«). Check
the tire pressure, if necessary correct it as
specified in the »Tech nical Data«.
26. Whenever assembling wheels retighten the wheel
bolts after the first 10 operating hours, then check
for tightness every 50 operating hours. Tightening
torques see »Technical Data«.
Assembly of wheels is only permitted when using
lifting gear of appropriate load bearing capacity for
the total weight of the respective round baler type.
27. Check tension and condition of the chains.
28. Check the oil level in the angular drives.
29. Check the oil level in the chain lubrication tank.
30. Never let roundbaler run without supervision.
To Next Page
Loading...
Need help?
General
