Cleaver-Brooks ClearFire CFLC-5000 - Page 193

Appendix D Falcon Alert, Hold, Lockout Codes
D-7
197 Invalid Interlock open response setting Lockout
198 Invalid Interlock start check setting Lockout
199 Invalid LCI enable setting Lockout
200 Invalid lightoff rate setting Lockout
201 Invalid Lightoff rate proving setting Lockout
202 Invalid Main Flame Establishing Period time setting Lockout
203 Invalid MFEP flame failure response setting Lockout
204 Invalid NTC sensor type setting Lockout
205 Invalid Outlet high limit response setting Lockout
206 Invalid Pilot Flame Establishing Period setting Lockout
207 Invalid PII enable setting Lockout
208 Invalid pilot test hold setting Lockout
209 Invalid Pilot type setting Lockout
210 Invalid Postpurge time setting Lockout
211 Invalid Power up with lockout setting Lockout
212 Invalid Preignition time setting Lockout
213 Invalid Prepurge rate setting Lockout
214 Invalid Prepurge time setting Lockout
215 Invalid Purge rate proving setting Lockout
216 Invalid Run flame failure response setting Lockout
217 Invalid Run stabilization time setting Lockout
218 Invalid Stack limit enable setting Lockout
219 Invalid Stack limit response setting Lockout
220 Unconfigured Delta T limit setpoint setting Lockout
221 Unconfigured DHW high limit setpoint setting Lockout
222 Unconfigured Outlet high limit setpoint setting Lockout
223 Unconfigured Stack limit setpoint setting Lockout
224 Invalid DHW demand source setting Lockout
225 Invalid Flame threshold setting Lockout
226 Invalid Outlet high limit setpoint setting Lockout
227 Invalid DHW high limit setpoint setting Lockout
228 Invalid Stack limit setpoint setting Lockout
229 Invalid Modulation output setting Lockout
230 Invalid CH demand source setting Lockout
231 Invalid Delta T limit delay setting Lockout
232 Invalid Pressure sensor type setting Lockout
233 Invalid IAS closed response setting Lockout
234 Invalid Outlet high limit enable setting Lockout
235 Invalid Outlet connector type setting Lockout
236 Invalid Inlet connector type setting Lockout
237 Invalid DHW connector type setting Lockout
238 Invalid Stack connector type setting Lockout
Table D-1 Falcon Holds and Lockouts (Continued)