Falcon Alert, Hold, Lockout Codes Appendix D
D-12
126 Modulation rate was limited due to anticondensation
127 Fan speed out of range in RUN
128 Modulation rate was limited due to IAS was open
129 Slow start ramp setting of zero will result in no modulation rate change
130 No forced rate was configured for slow start ramp
131 CH demand source was invalid
132 CH P-gain was invalid
133 CH I-gain was invalid
134 CH D-gain was invalid
135 CH OFF hysteresis was invalid
136 CH ON hysteresis was invalid
137 CH sensor type was invalid
138 CH hysteresis step time was invalid
139 CH remote control parameter was invalid
140 CH ODR not allowed with remote control
141 Steam P-gain was invalid
142 Steam I-gain was invalid
143 Steam D-gain was invalid
144 Steam OFF hysteresis was invalid
145 Steam ON hysteresis was invalid
146 CH control was suspended due to fault
147 CH header temperature was invalid
148 CH Outlet temperature was invalid
149 CH steam pressure was invalid
150 Steam setpoint source parameter was invalid
151 Minimum water temperature parameter was greater than setpoint
152 Minimum water temperature parameter was greater than time of day setpoint
153 Minimum pressure parameter was greater than setpoint
154 Minimum pressure parameter was greater than time of day setpoint
155 CH modulation rate source parameter was invalid
156 Steam modulation rate source parameter was invalid
157 DHW demand source was invalid
158 DHW P-gain was invalid
159 DHW I-gain was invalid
160 DHW D-gain was invalid
161 DHW OFF hysteresis was invalid
162 DHW ON hysteresis was invalid
163 DHW hysteresis step time was invalid
164 DHW sensor type was invalid
165 Inlet sensor type was invalid for DHW
166 Outlet sensor type was invalid for DHW
167 DHW storage OFF hysteresis was invalid
Table D-2 Falcon Alerts (Continued)
To Next Page
Loading...
