Appendix D Falcon Alert, Hold, Lockout Codes
D-13
168 DHW storage ON hysteresis was invalid
169 DHW modulation sensor type was invalid
170 DHW modulation sensor was not compatible for Auto mode
171 DHW control was suspended due to fault
172 DHW temperature was invalid
173 DHW inlet temperature was invalid
174 DHW outlet temperature was invalid
175 DHW high limit must be disabled for Auto mode
176 DHW sensor type was not compatible for Auto mode
177 DHW priority source setting was invalid
178 DHW priority method setting was invalid
179 CH S5 (J8-11) sensor was invalid
180 CH Inlet temperature was invalid
181 CH S10 (J10-7) sensor was invalid
182 Lead Lag CH setpoint source was invalid
183 Lead Lag P-gain was invalid
184 Lead Lag I-gain was invalid
185 Lead Lag D-gain was invalid
186 Lead Lag OFF hysteresis was invalid
187 Lead Lag ON hysteresis was invalid
188 Lead Lag slave enable was invalid
189 Lead Lag hysteresis step time was invalid
190 No Lead Lag Modbus port was assigned
191 Lead Lag base load common setting was invalid
192 Lead Lag DHW demand switch setting was invalid
193 Lead Lag Mix demand switch setting was invalid
194 Lead Lag modulation sensor setting was invalid
195 Lead Lag backup modulation sensor setting was invalid
196 Lead Lag slave mode setting was invalid
197 Lead Lag rate allocation setting was invalid
198 Lead selection setting was invalid
199 Lag selection setting was invalid
200 Lead Lag slave return setting was invalid
201 Lead Lag add stage method setting was invalid
202 STAT may not be a Lead Lag CH demand source when Remote Stat is enabled
203 Lead Lag base load rate setting was invalid
204 Lead Lag master was suspended due to fault
205 Lead Lag slave was suspended due to fault
206 Lead Lag header temperature was invalid
207 Lead Lag was suspended due to no enabled Program Module installed
208 Lead Lag slave session has timed out
209 Too many Lead Lag slaves were detected
Table D-2 Falcon Alerts (Continued)
To Next Page
Loading...
