ComAp InteliDrive DCU Marine - Page 31

ID-DCU-MARINE-2.2.2, ©ComAp – June 2015 - 31 -
ID-DCU-MARINE-2.2.2.pdf
95 mm
(3,7´)
43 mm
(1,7´)
96 mm (3,8')
Power
supply
I-AOUT8
ComAp
HW:
SW:
+ 8-36 VDC GND
AGND
AOUT5
AGND
AOUT6
AGND
AOUT7
AGND
AOUT8
ANALOG OUTPUTS
AOUT1 AGND AOUT2 AGND AOUT3 AGND AOUT4 AGND
ANALOG OUTPUTS
CANL
CCOM
CANH
CAN
U - I - p
U - I - p
U - I - p
U - I - p
p - I - U
p - I - U
p - I - U
p - I - U
1 2 Pwr
120 ohm
Functions
Number of analog
outputs
8, no galvanic separation
Type of analog outputs
(jumper selectable)
U
I
p
0 to 10VDC ± 1% , max 5 mA
0 to 20 mA ± 1% , max 500  - default
pwm 1200 Hz, 5V level, max 10 mA
Power supply
8 to 36 VDC
Current consumption
100 ÷ 300 mA at 24 VDC
Communication interface
CAN1, with jumper selectable address 1 to 4
Jumper selectable terminating resistor 120 .
RS232 interface
TTL, firmware upgrade via AT-link.
Operating temperature
range
-40°C to +70°C
Analog outputs
refreshment
Max. 300 ms
CAN address jumper setting
Up to four modules can be connected to one controller. Set module CAN address corresponding to
configuration according table below.
CAN Address
Jumper 1
Jumper 2
1
No
No
2
Yes
No
3
No
Yes
4
Yes
Yes