Develop D 16G - Service Mode Functions

S-12
4-3. Service Mode Functions
(1) Service's Choice
• Various machine service functions can be specified.
Function Purpose Setting Details/Precautions
SHIPMENT
DESTINATION
To switch the fixed zoom ratios and
paper sizes according to the
selected marketing area.
• The default setting is either
“METRIC” or “INCH”.
METRIC INCH
LEADING EDGE
ERASE
To change the laser emission tim-
ing to adjust the width of the image
area that is erased at the leading
edge.
✽ When the PH unit has been
replaced
• The default setting is “4mm”.
0mm 1mm 2mm 3mm
4mm
5mm
TRAILING EDGE
ERASE
To change the laser emission tim-
ing to adjust the width of the image
area that is erased at the trailing
edge.
✽ When the PH unit has been
replaced
• The default setting is “4mm”.
0mm 1mm 2mm 3mm
4mm
5mm
VERTICAL EDGE
ERASE
To change the laser emission tim-
ing to adjust the width of the image
area that is erased on both sides
(CD direction).
✽ When the PH unit has been
replaced
Select the value for the width
erased in the CD direction. (The
default setting is “4mm”.)
0mm 1mm 2mm 3mm
4mm
5mm
FLS PAPER SIZE
To specify the paper size for
foolscap.
✽ When the FLS paper size has
been changed
✽ Upon setup
• The default setting is
“330∗210”.
330∗203 330∗210
330∗216 337∗206
GDI TIMEOUT
To specify the time for GDI timeout • The default setting is “6” (60
seconds).
0 (5sec.) 1 (10sec.) 2 (20sec.)
3 (30sec.) 4 (40sec.) 5 (50sec.)
6 (60sec.)
TONER EMPTY
STOP
To select if copy operations are
stopped when the toner becomes
empty.
• The default setting is “ON”.
ON OFF
• If “OFF” is selected, opera-
tions are not stopped when
the toner becomes empty.