S-8
(2) Paper Source Setting
• Various settings for the paper tray can be specified.
(3) Copy Setting
• The default settings for each copy function can be specified.
No. Function Purpose Setting Details/Precautions
1
TRAY1
PAPER
To specify the type and size of
paper loaded into Tray1.
• The default settings are
“PLAIN” in addition to “A4 L”
or “LT”.
<Procedure>
1. Select the paper type.
PLAIN
OHP CARD ENVELOPE
2. Select the paper size.
A5 B5 A4 FLS 16K HL LT LG
NOTE
If “OHP” is selected as the
paper type, only “A4” and “LT”
are available as paper sizes.
3. To specify a custom paper
size, type in the size.
2
TRAY
SETTING
To specify whether or not auto tray
switching is enabled for each
paper tray.
• The default setting is “CON-
TINUOUS”.
FIXED CONTINUOUS
No. Function Purpose Setting Details/Precautions
1
PAPER
PRIORITY
To specify the paper tray that is
given priority.
•
The default setting is “TRAY1”.
TRAY1 TRAY2
2
DENSITY PRI-
ORITY
To specify the image density set-
ting that is selected when the
machine is turned on or the Panel
Reset key is pressed.
• The default setting is
“AUTO”.
AUTO MANUAL PHOTO
3
DENSITY
LEVEL (A)
To specify the default density level
when the Auto setting is selected.
• The default setting is “NOR-
MAL (0)”.
The setting range is -1 to +1.
4
DENSITY
LEVEL (M)
To specify the default density level
when manually setting the image
density.
• The default setting is “NOR-
MAL (0)”.
The setting range is -4 to +4.
5
OUTPUT PRI-
ORITY
To specify the default finishing set-
ting.
• The default setting is “NON”.
NON SORT
6 RESOLUTION
To specify the scanning resolution.
The default setting is “600
×
300”.
600×300 600×600
To Next Page
Loading...
