G-5
3. PRECAUTIONS FOR USE
3-1. To Ensure the Printer is Used in an Optimum Condition
• Never place a heavy object on the printer or subject the printer to shocks.
• Insert the power plug all the way into the outlet.
• Do not attempt to remove any panel or cover that is secured while the printer is in a print
cycle.
• Do not turn OFF the printer while it is in a print cycle.
• Provide good ventilation if the printer is to be used for a long time in a narrow room.
• Never use flammable sprays near the printer.
• If the printer becomes inordinately hot or produces abnormal noise, immediately turn it
OFF and unplug it.
• Do not turn ON the power switch at the same time that you plug the power cord into the
outlet.
• When unplugging the power cord, do not pull on the cord; hold the plug and pull it out.
• Do not bring any magnetized object near the printer.
• Do not place a vase or vessel containing water on the printer.
• Be sure to turn OFF the power switch at the end of the workday or upon power failure.
• Use care not to drop paper clips, staples, or other small pieces of metal into the printer.
3-2. Operating Environment
The operating environmental requirements of the printer are as follows.
• Temperature: 10 to 30 °C
• Humidity: 15 to 85 %
• Rate of temperature change: 10 °C/h
• Rate of humidity change: 20 %Rh/h
3-3. Power Requirements
The power source voltage requirements are as follows.
• Voltage fluctuation: AC110 V -10 %, AC127 V +6 % (Function)
AC220-240 V ± 10 % (Function)
AC110 V -15 %, AC127 V +6 % (Paper Feeding)
AC220-240 V +10 %, -15 % (Paper Feeding)
• Frequency fluctuation: 50/60 Hz ± 3 Hz
To Next Page
Loading...
