M-3
8. Paper Feed
• Paper is fed from Tray 1.
9. Bypass Paper Feed
• Paper is fed from the Multiple Bypass Tray.
10. Image Transfer
• A DC positive charge is applied to the Image Transfer Roller to transfer the visible image
on the surface of the PC Drum onto the paper.
11. Paper Separation
• The Charge Neutralizing Plate neutralizes any charge left on the paper.
12. Recovery
• The residual toner on the surface of the PC Drum is temporarily recovered and is made
into even finer particles during the print end sequence before being recovered at the
Developing Unit.
13. Paper Transport
• The paper is transported onto the Fusing Unit.
14. Fusing
• The developed image is permanently fused to the paper by a combination of heat and
pressure applied by the Right and Left Fusing Rollers.
15. Paper Exit
• The paper is fed out onto the Exit Tray.
To Next Page
Loading...
